Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2000, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 3 Jan 2000 21:05:01 -0500
Reply-To:     John Lauterbach <jhlauterbach@EMAIL.MSN.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         John Lauterbach <jhlauterbach@EMAIL.MSN.COM>
Organization: Microsoft Corporation
Subject:      Re: dumb question dept
Comments: To: Woody Halsey <WoodyHalsey@COMPUSERVE.COM>

Woody, I just had to overcome the same problem.  Find the appropriate
electrical schematic.  Disconnect connector from ECU along with connectors
from Temp Sensor II and Ignition Control module (pinouts are marked on that
connector).  On my '84, pin 1 of connector to ECU goes to pin 7 of ignition
control.  I used ohm meter to confirm connection and the double checked by
ohming out pin to Temp Sensor II


John Lauterbach
Macon, GA


----- Original Message -----
From: Woody Halsey <WoodyHalsey@COMPUSERVE.COM>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Monday, January 03, 2000 4:34 PM
Subject: dumb question dept




Dear List,


Please forgive me, but I have flipped through the Bentley twice and cannot
find the picture of the multipoint connector  to the ECU that identifies
all the pins. Can someone give me the page reference? I know it's in there
somewhere.


Thanks!


Woody
Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.