Date:         Sun, 2 Jan 2000 16:06:34 -0500
Reply-To:     John Lauterbach <jhlauterbach@EMAIL.MSN.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         John Lauterbach <jhlauterbach@EMAIL.MSN.COM>
Organization: Microsoft Corporation
Subject:      Temp II sensor

It would be appreciated if someone could confirm a resistance measurement
for the Temp II sensor.  I am getting 2800 ohms at an ambient temperature
(presume van is at ambient since it hasn't run in over 24 hours) between pin
2 on the cable leading to the ECU and ground (alternator shell or other
point on frame).  What I am calling pin 1 on cable leads to pin 7 on
Ignition Control Module.

Thank you very much in advance.

John Lauterbach
Macon, GA

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.