I have finally finished getting together the kit for putting the inline 4-cylinder motor (Jetta, Golf, Scirocco) into a waterboxer Vanagon. Most of the parts are VW factory parts. The kit is $2200 and includes: All preformed coolant hoses Expansion Tank Accelerator Cable Accessory Brackets for mounting power steering, Alternator, and Air Conditioning compressor. Adapter Plate and Flywheel (Manual Trans) Sachs Clutch Kit Special Oil Pan and Pickup tube Both engine mounts and engine carriers. The kit is setup to put the engine as the stock Diesel Vanagon tilt to allow the motor to fit under the rear deck lid with no modifications. You may have to modify your driver's side firewall depending on which engine you use. The "kit" doesn't come with instructions. If you have any questions please email me or call at one of the numbers below. Thanks, Ken Wilford http://www.vanagain.com John 3:16 Phone: (856)-765-1583 Shop: (856)-327-0027 Fax: (856)-327-2242 |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.