I tried to send this to one the Syncro list but it bounced. Maybe I'll have better luck with Gerry? ----- Original Message ----- From: Tim King <tking_ms@msn.com> To: <Syncro@onelist.com> Sent: Tuesday, January 11, 2000 3:27 PM Subject: Driveshaft U-joint removal?
> Hey folks... Any tips on getting the U-joint off the driveshaft? Shaft is > out and I have the new joint I'm dying to get it in. > > I did one end of the shaft using a lug bolt, big clamp, drift, and about > three hours of my free (ha ha) time. Going in was easy with the very large > (20" throat) C-clamp method. However for the rubber damper end of the shaft, > I don't want to take any chances removing the joint with the drift (or my > limited supply of time). Any advice appreciated. > > BTW, I got weasler joints for about $30 a pop (locally; they actually quoted > 17, then shafted me when I picked them up, but that's another story). I > found the same ones via and internet supplier for $14.11/ea. Once I get the > final end in and road test it I'll post the part numbers (again -- I > actually got them from the archives). > > Thanks, > > Tim King > Seattle, WA > 87 Syncro/2 Westy > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.