Hi Richard, Piece of cake The syncro transaxle input shaft used in our vans is very similar to the bus 091 and 002 transaxle. Since you have the engine pulled just drain the oil pull the bellhousing, you will find about the same setup. Circlip that hold the sleeve in place on the input shaft must have come loose and slid toward the engine during hard acceleration. (^_^) smile..... If you need a new bell housing gasket napa has bulk gasket material that works well if you want to make your own. You might consider installing a new input shaft seal. Darrell Boehler Makanda Illinois
----- Original Message ----- From: Richard Meissenheimer (by way of Derek Drew <drew@interport.net>) <bonnie_baker@TELUS.NET> To: <vanagon@GERRY.VANAGON.COM> Sent: Tuesday, January 11, 2000 6:39 AM Subject: Euro-Trans: 91 Volkswagen Vanagon , Mechanical, input shaft
> iATN Help: send blank email to: help@i-atn.com > Upgrade: http://members.iatn.net/enhanced.html > Archives: http://members.iatn.net/sponsorsindex.html > Post Message: http://members.iatn.net/email/ > _______________________________________________________ > > 1991 Volkswagen Vanagon 2.1 L > > Trans: Standard > Mileage: 202,000 kilometers > VIN: WV2ZB0256MG009522 > > Misc Data: synchro > Affected Item: input shaft > Condition: came out > > ____________________________________________________________ > > I am replacing the engine in this vehicle. When I tried to > remove the engine, the input shaft came part way out of the > transaxle. I have rebuilt many air cooled transaxles and I > know that they have a two piece input shaft held together > by a stud and sleeve. Does this transaxle have the same set > up, and can I do the repair without taking the transaxle > out and completely apart? I have no manuals and there is no > dealer within 300 miles. Thanks in advance. > > > Richard Meissenheimer > bonnie_baker@telus.net > Technician/Shop Foreman > Lakeside Auto Sales > Nelson, British Columbia, Canada > > _______________________________________________________ > iATN Industry Sponsors: http://www.iatn.net/atn/ > iATN WebSite: http://members.iatn.net/index.asp > Guidelines: http://www.iatn.net/guide.html > To configure or cancel your iATN account see: > http://members.iatn.net/config/index.asp > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.