Date: Sat, 15 Jan 2000 10:56:49 PST
Reply-To: Sean Cole <yturn@HOTMAIL.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Sean Cole <yturn@HOTMAIL.COM>
Subject: Re: Euro-Elec: 91 Volkswagen Vanagon, idiot lights, oil light
Content-Type: text/plain; format=flowed
I encountered same oil pressure idicator problem last year accompanied by an
irritating buzzer. First I checked the oil pressure with an analog guage
and found sufficient oil pressure. I deduced I must have a bad sensor.
After replacing all the sensors, the problem still existed. Logically, this
left the console as the culprit. Next I installed an oil pressure guage and
ripped out the buzzer and LED corresponding to my problem. I've been fine
for over a year now.
Sean
87 Westy
>From: "Richard Meissenheimer (by way of Derek Drew
><drew@interport.net>)" <bonnie_baker@TELUS.NET>
>Reply-To: "Richard Meissenheimer (by way of Derek Drew
><drew@interport.net>)" <bonnie_baker@TELUS.NET>
>To: vanagon@GERRY.VANAGON.COM
>Subject: Euro-Elec: 91 Volkswagen Vanagon, idiot lights, oil light
>Date: Sat, 15 Jan 2000 09:51:46 -0500
>
>iATN Help: send blank email to: help@i-atn.com
>Upgrade: http://members.iatn.net/enhanced.html
>Archives: http://members.iatn.net/sponsorsindex.html
>Post Message: http://members.iatn.net/email/
>_______________________________________________________
>
>1991 Volkswagen Vanagon 2.1 L
>
>Trans: Standard
>Mileage: 200,000 kilometers
>VIN: WV2ZB0256M
>
>Misc Data: Synchro
>Affected Item: oil light
>Condition: flashing
>
>____________________________________________________________
>
>After installing replacement engine, oil light flashes when
>engine is warm and idling. I installed a new grey oil
>pressure sensor in the port below the water pump. This did
>not change anything. I then found out that there is a
>second oil pressure sensor between the push rod tubes on
>the left side of the engine. I replaced that one with a
>known good grey switch. This did not change anything. I
>have not checked the actual pressure because I do not have
>the necessary adapters for my oil pressure gauge, and also
>because of the inaccessibility of the ports. I measured the
>resistance of the switches and found them to be 2.5k with
>the engine off and about 400 with the engine running. Can
>anyone explain to me how this system works? Things were so
>much simpler when VW's used air to cool their engines!
>Thank you in advance.
>
>
>Richard Meissenheimer
>bonnie_baker@telus.net
>Technician/Shop Foreman
>Lakeside Auto Sales
>Nelson, British Columbia, Canada
>
>_______________________________________________________
>iATN Industry Sponsors: http://www.iatn.net/atn/
>iATN WebSite: http://members.iatn.net/index.asp
>Guidelines: http://www.iatn.net/guide.html
>To configure or cancel your iATN account see:
>http://members.iatn.net/config/index.asp
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com
|