Help! I am sure that I am in over my head now, but I will be a better person for the experience <insert ascii art crossed fingers here>
I have a half shaft out of my Syncro with new boots waiting to be installed and I am stuck on removing the CV joints from either end. Bently shows using a press on the inners, but seems to indicate that you just remove the spring fastener from the outer and slip off the joint while tapping lightly with a copper(?) mallet. Hmm. I don't have a copper mallet and even if I did, I am not sure where or how to tap. Is there any way I am going to do this at home using basic tools and no press or do I need to take it to a shop? Thanks, John-Reed Maffeo '86 Syncro - Glacie Mesa, AZ (at least it is warm here) |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.