Hello Chris; Please don't be discouraged by your lack of success. As a mechanic, I deal with that situation rather a lot. I would first attempt to burn the lugnut off with a torch, I can cut clean enough that I don't touch the threads. If I didn't have that option, I guess I would heat it in some way. I have access to an excellant tool source, and would use (or try) a pipe wrench, or a pair or parrot-nosed pliers. After you remove the fastener you must chase the thread you might have damaged. Geez it's starting to sound daunting, if you screw it up you will have to buy a new stud and install it, you just drive it out with a soft hammer. then install the new one from the inside. Another possibility would ber to grind it off, with one of those disc grinders 4inch. I've had to do that a few times. Most of all don't be discouraged, your efforts will be rewarded. It helps to strengthen the bond with the machine. Larry |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.