I have eben adjusting valves for years but a VW 2.0 is unique. Because the engine is mounted horizontal you really have to double check and insure the push rods are seated properly. Whats unique about the vw air cooled is number one cylinder isn't where most engines have them. To me number three should be number one since it is the first to connect the crankshaft. Now most engines out there you can adjust certain valves depending where the crankshaft is relative to the cam shaft...in another words you can put number 1 cyl tdc and you will be able to adjust half the intake and exhaust valves depending the service manual procedure. Then a simple rotation of 180 degrees will allow you to adjust the remaining valves. Does anyone know if this can be done. I read some articles on the 6 mils...what is 6 mils and does this pertain hyd lifters. The bently book says 2 complete turns one listee said 1 turn and the vw mechanic said 1 and 1/2...whos right or which one is better. Is there a better procedure. Andy Wild Wild Westy 82 |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.