Tony, First, you need to keep in mind that coolant and the fumes from coolant are toxic. Personally, I would want to get it cleaned up before I spend any time in the driver's seat... especially with the windows rolled up! While cleaning up I would use rubber gloves and a respirator. Also, I have heard that is such extreme conditions as your leak sounds that it is recommended to remove the rear seat and cabinets so you can get to the flooring and remove and replace it... you don't need flooring soaked in a toxic substance. Second, Bus Depot sells heater cores... that is most likely the fix you need. What I did was to just remove the heater because I don't use it anyway and that gives me more room under the rear seat. But don't us a U to connect the two hoses as that will give the coolant a short cut back to the engine before it has a chance to go forward to the radiator to cool. I used brass fittings to plug both hoses off... two barbed by threaded fittings and two brass threaded caps.. used the original clamps to assume snug fit to the barbed fittings. Good Luck, Bill -----Original Message----- From: Tony DeMille <dubstar@XMISSION.COM> To: vanagon@GERRY.VANAGON.COM <vanagon@GERRY.VANAGON.COM> Date: Monday, February 21, 2000 10:48 AM Subject: REAR HEATER Repair/By-pass advice
>list, > >i'm having a serious coolant leak coming from my rear (under bench) heater >in my '90 vanagon. (by serious i mean it has soaked my padding and carpet >twice all the way up to the behind the front seats) i need to know what to >do. > >i've removed the outermost housing and have discovered coolant build-up >around the bottom of the fins on the radiator unit. it appears to be leaking >around there and coming out of the seam of bottom of the housing surrounding >that core unit. (i should note here that the hoses and other usual leak >areas appear to be fine) does this mean that the radiator unit is shot? is >there a "stop leak" type fix? should i create some kind of "U" joint for the >hoses to bypass the heater unit and take it out until i can repair or >replace it? and if i make the "U" joint, does disconnecting the heater mean >i have to bleed the system after i'm done because i've let air in? >basically, what is the best thing to do? > >this problem has gotten continually worsened to the point that my coolant >sensor light comes on. > >any information on this subject will be immensly appreciated. > >p.s. for those of you that care, i was on this list for a year or two until >last year. remember, my '87 caught on fire in the taco bell parking lot? >it's nice to be back. i've missed the list. i hope all is well in v-land > >thank you in advance. > >Tony >'90 GL > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.