Date: Tue, 15 Feb 2000 02:02:21 -0500
Reply-To: "Richard Meissenheimer (by way of Derek Drew
<drew@interport.net>)" <bonnie_baker@TELUS.NET>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: "Richard Meissenheimer (by way of Derek Drew
<drew@interport.net>)" <bonnie_baker@TELUS.NET>
Subject: Euro-Elec: FIX 91 Volkswagen Vanagon, idiot lights, oil light
Content-Type: text/plain; charset="us-ascii"; format=flowed
*******************************************************
Sponsoring members may rate this FIX post
or add/view comments directly from this link:
http://members.iatn.net/c/c.cgi?i=11175&t=euro
*******************************************************
1991 Volkswagen Vanagon 2.1 L
Trans: Standard
Mileage: 200,000 km
VIN: WV2ZB0256M
Misc Data: Synchro
Affected Item: oil light
___________________________ FIX: ___________________________
Thanks for the 30 or so replies I received. We decided that
22 psi @ 2000rpm with 20W50 oil was too low, so we returned
the used engine to its source and installed a VW Canada
rebuild with the customer's concurrence. The lesson, I
guess is that when you obtain a used engine from an unknown
source, don't accept anything that they tell you about it.
They said they had checked the compression and oil pressure
on this one, yet both oil pressure switched were buried in
filth and the spark plug connectors were heat welded to the
plug insulators!
____________________ ORIGINAL MESSAGE: _____________________
After installing replacement engine, oil light flashes when
engine is warm and idling. I installed a new grey oil
pressure sensor in the port below the water pump. This did
not change anything. I then found out that there is a
second oil pressure sensor between the push rod tubes on
the left side of the engine. I replaced that one with a
known good grey switch. This did not change anything. I
have not checked the actual pressure because I do not have
the necessary adapters for my oil pressure gauge, and also
because of the inaccessibility of the ports. I measured the
resistance of the switches and found them to be 2.5k with
the engine off and about 400 with the engine running. Can
anyone explain to me how this system works? Things were so
much simpler when VW's used air to cool their engines!
Thank you in advance.
Richard Meissenheimer
bonnie_baker@telus.net
Technician/Shop Foreman
Lakeside Auto Sales
Nelson, British Columbia, Canada
_______________________________________________________
iATN Industry Sponsors: http://www.iatn.net/atn/
iATN WebSite: http://members.iatn.net/index.asp
Guidelines: http://www.iatn.net/guide.html
To configure or cancel your iATN account see:
http://members.iatn.net/config/index.asp