Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2000, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Thu, 2 Mar 2000 09:11:55 EST
Reply-To:   KENWILFY@AOL.COM
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   KENWILFY@AOL.COM
Subject:   Re: stripped flywheel bolt
Comments:   To: wolzphoto@worldnet.att.net
Content-Type:   text/plain; charset="US-ASCII"

Had this happen recently. Used a grinder to grind new flats on the bolt head and then an impact air wrench to brake it loose (it was on there). Just keep grinding a little and then comparing it to the socket you want to put on there (6 point if you have one) and you'll get it. Hope this helps.

Ken Wilford http://www.vanagain.com John 3:16 Office (856)-765-1583 Shop (856)-327-0027 Fax (856)-327-2242


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.