|
When I went to remove my flywheel today, I found that all of the hex bolts had been rounded a bit by the engine's previous owner. I managed to get four of them out with no real problems (just hammered the wrench into the bolt head). The last one was, and now is more of, a mess. I had applied WD-40, tapped it with a hammer, and applied heat. Any suggestions on what to do now? I'm planning on drilling it out tomorrow. Thanks, Karl Wolz |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.