Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2000, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Thu, 2 Mar 2000 08:54:43 -0500
Reply-To:   Zoran_Mladen@AMSINC.COM
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   Zoran Mladen <Zoran_Mladen@AMSINC.COM>
Subject:   Re: stripped flywheel bolt
Comments:   To: Karl Wolz <wolzphoto@WORLDNET.ATT.NET>
Content-type:   text/plain; charset=us-ascii

Do you have a compressor with an impact chisel by any chance? This works best. The problem with heating is that you want to heat the crankshaft so that it expands, not the bolt. If you heat the bolt, you make the problem worse. Unfortunately, you can't get to the crankshaft to heat it.

Z

Karl Wolz <wolzphoto@WORLDNET.ATT.NET> on 03/01/2000 11:11:35 PM

Please respond to Karl Wolz <wolzphoto@WORLDNET.ATT.NET>

To: vanagon@GERRY.VANAGON.COM cc: (bcc: Zoran Mladen/AMS/AMSINC) Subject: stripped flywheel bolt

When I went to remove my flywheel today, I found that all of the hex bolts had been rounded a bit by the engine's previous owner. I managed to get four of them out with no real problems (just hammered the wrench into the bolt head). The last one was, and now is more of, a mess. I had applied WD-40, tapped it with a hammer, and applied heat. Any suggestions on what to do now? I'm planning on drilling it out tomorrow.

Thanks,

Karl Wolz


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.