Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2000, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 12 Mar 2000 16:35:00 -0800
Reply-To:     Joel Cort <joel_cort@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Joel Cort <joel_cort@YAHOO.COM>
Subject:      Re: brake bleeder size
Comments: To: Brent Christensen <bpchristensen1@HOME.COM>
Content-Type: text/plain; charset=us-ascii

I just change my master cylinder on my 89 Syncro Westy and mine has the same size bleeders front and rear. All worked well with the 7mm wrench and one daughter to push on the brakes.

Joel Rochester NY.

--- Brent Christensen <bpchristensen1@HOME.COM> wrote: > I don't know about different model years, etc. But > on my '89 Syncro, the > front bleeder screws are 7mm and the rears are 8mm. > Go figure.. :-) (May > have been changed by the PO - they also have > different looking caps on > them). > > Brent Christensen > '89 GL Syncro Westy "Klaus" > Santa Barbara, CA > > -----Original Message----- > From: Vanagon Mailing List > [mailto:vanagon@GERRY.VANAGON.COM]On Behalf > Of Lee Roesner > Sent: Sunday, March 12, 2000 3:34 PM > To: vanagon@GERRY.VANAGON.COM > Subject: brake shoes cont. > > > The grand prize goes to Brent Christensen as he > seems to have had the > correct answer. Thanks Brent. > > After some re-adjustments of brake settings and a > thorough search for > the 7mm wrench in my garage (which I did not > find-found everything > but-so I did not bleed brakes yet) I still had same > mushy brakes. But > after careful review of the master cylinder and > master brake fluid > reservoir noticed it was at minimum level. Yep. > Looks like the level was > to low to begin with and bet I introduced air to the > lines. > > Going out tomorrow to buy fluid and a 7mm wrench > (right one I hope?) and > bleed brakes. Is there a wheel order I should follow > to bleed these > brakes? > > Thanks, > Lee > -- > Lee Roesner > PARADIGM Graphic Design & Web Development > Northbrook Office 847-509-8704 > Fax: 847-480-5701 > Home Office: 815-385-2969 > Fax: 815-385-2994 > PORTFOLIO: http://www.roesner.net/vw > __________________________________________________ Do You Yahoo!? Talk to your friends online with Yahoo! Messenger. http://im.yahoo.com


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.