In a message dated 3/28/00 7:29:40 PM, kdosmm@WORLDNET.ATT.NET writes: << On my 1984 GL, the insulation is worn down to bare wire where it goes under the heat shielding covering the push rod tubes. Does anyone have any ideas on how to reinsulate the wiring? >> Scott, Do not re-insulate, remove and replace the wiring with Teflon insulated wire. I think I used 20ga on mine. Do yourself a favor and take the trouble to scrounge up a few feet of the Teflon insulated wire; miles from now it will prove worth the effort. Also, make certain the wire is not pinched between the engine tin and the head. Rich |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.