Inline four cylinder engines with exhaust manifolds and flywheel weigh in at ~250lbs. Just the block is under 150lbs. I have found engine stands are too large for the VW engines! I got my machine shop to make a ring that is the same size as the bellhousing and weld nuts onto that so the "fingers" on the engine stand can spread out far enough and evenly. Personally I would look into getting a new 1.9L engine and installing it... 75hp is a lot better than 48!
At 10:04 PM 02/04/2000 -0400, Cesar Baptista wrote: > > I have two spare 1.6's that I wish to rebuild work on. > > Is it necessary to get an engine stand to rebuild them? If so what should >I look for, brand name or just weight capacity? How much does a 1.6 deisel >engine weigh anyway? shop tools? How about VW-specific tools (like >timing and compression tools)? > > -- David Marshall - - Quesnel, BC, Canada -- -- 78 VW Rabbit, 80 VW Caddy, 84 VW Westie, 85 VW Cabriolet -- -- 87 Audi 5000 Quattro, 88 2.0L VW Syncro Double Cab -- -- David's Volkswagen Home Page http://www.volkswagen.org -- -- Fast Forward Autobahn Sport Tuning http://www.fastforward.ca -- -- david@volkswagen.org (pmail) or vanagon@volkswagen.org (list) -- |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.