I have my bus running again after the engine fire. Lots of new parts and pieces. starts good idle is approximately 800-850 rpm. When I put it in drive, it stalls. Is there some mechanism to kick up the idle when selecting a gear? Or, is my idle to low? I have a Bently manual and have not done the checks there yet. I had reinstalled the throttle return spring on the wrong side of the throttle valve and then monkeyed with the throttle linkage adjustment at the gas pedal and the linkage for adjusting the kick down actuator. I am hoping to go for the smog, headlight and brake check required to get my girl back on the road this weekend. YIPEE! Cary in San Jose, CA. '85 Westy "Turtle Girl" |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.