I am going to install a new clutch. I will also remove the flywheel and have it machined. So how do I align the pressure plate in the correct location? (since it doesn't matter how the flywheel goes on, and the dowl pin can be positioned anywhere? or can it?) TIA jamie foust ----- Original Message ----- From: <DrVic955@aol.com> To: <catndogs@earthlink.net> Sent: Thursday, April 06, 2000 12:56 AM Subject: Re: 82 DIESEL FLYWHEEL
> Hi there, > > While it's impossible to put the flywheel on wrong, it is possible to put the > pressure plate on wrong, especially if the locating pins on the flywheel for > the pressure plate are missing or damaged. The timing mark on the vanagon > diesel is actually on the pressure plate itself, not on the flywheel. > > Cheers, > > Vic > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.