Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 2000, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 1 Apr 2000 22:53:01 -0500
Reply-To:     John Anderson <jander14@WVU.EDU>
Sender:       Vanagon Mailing List <>
From:         John Anderson <jander14@WVU.EDU>
Subject:      Re: Bypassing rear heater core?
Comments: To: Todd Lund <westy4us@YAHOO.COM>
In-Reply-To:  <>
Content-Type: text/plain; charset="us-ascii"

At 10:02 AM 4/1/00 -0800, you wrote: >I have searched the archives and their seams to be >conflicting information after removing the rear heater >core. Should you connect the lines together or plug >them both?

Plugging is hardly gorgeous, if you don't want incorrect mixing hot to cold to detriment the front core, just get new non straight nylon or brass (make sure the nylon is hot water rated) couplers and replace the T's, looks factory no ugly coolant hose hanging around.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.