Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 2000, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 13 Apr 2000 17:54:42 -0700
Reply-To:     Davidson <wdavidson@THEGRID.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Davidson <wdavidson@THEGRID.NET>
Subject:      Re: Westy Power Cord
Comments: To: David Beierl <dbeierl@ibm.net>
Content-Type: text/plain; charset="iso-8859-1"

David, You're right... another mistake... guess I should think a little more before answering... Thanks for the corrections.. Bill -----Original Message----- From: David Beierl <dbeierl@ibm.net> To: Davidson <wdavidson@THEGRID.NET> Cc: vanagon@GERRY.VANAGON.COM <vanagon@GERRY.VANAGON.COM> Date: Thursday, April 13, 2000 5:27 PM Subject: Re: Westy Power Cord

>At 19:27 4/13/2000, Davidson wrote: >>The fridge draws about 8 amps... the cabin light probably 2 amps... add >>the amps of what ever else you want to run (the stock radio connection is >>off the starter battery unless you change it)... total and then go look >>for your power cord. > >I think you had a brain hiccup, Bill -- I know that you know that the >fridge draws 8 amps at 12 volts, less than one amp at 110. > >The Westy circuit breaker is rated 15 amps -- the cord you get should also >be rated at least 15 amps. The Westy comes with a fairly short 14-gauge >(maybe even 16 ga?) -- it's enormously thick, but that's because it's >RV-rated wire that's expecting to be driven over sometime in its >lifetime. OK IMO to use regular outdoor cords, but you lose that margin of >safety. The actual wire gauge of the cord should depend on how long it is >-- I run a 100-ft/30m cord and it is 12 ga to carry 15 amps that >distance. And since I've been known to use an electric heater, I sometimes >use 15 amps. But even if you never do, in order for the Westy breaker to >properly protect the cord, it needs to be rated the same or higher as the >breaker. > >Incidentally, I cut out one side of the aluminum shroud around the circuit >breaker button, so that I could get a fingernail in and shut off the >breaker -- the camper manual speaks of it as a power switch as well as c.b. >but they made it impossible to use without a hooked tool of some sort. > >david > >David Beierl - Providence, RI > http://pws.prserv.net/synergy/Vanagon/ >'84 Westy "Dutiful Passage" >'85 GL "Poor Relation" > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.