Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (April 2000, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 18 Apr 2000 20:32:00 EDT
Reply-To:     KENWILFY@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         KENWILFY@AOL.COM
Subject:      Re: Cylinder Sleeves Quick Question
Comments: To: bostneng@fcl-us.net
Content-Type: text/plain; charset="US-ASCII"

In a message dated 4/18/00 7:47:40 PM Eastern Daylight Time, bostneng@FCL-US.NET writes:

<< they also need to be washed out to remove the bits of cylinder before the pistons are installed Bob >> You can buy a decent stone hone for not too much money at your local flaps. Use a variable speed drill with a slow speed. You need to match your rotation speed with the "in and out motion" of the hone to get the proper crosshatching pattern. Use some light oil for honing and then use either Auto Tranny Fluid or Marvel Mystery Oil (are they the same thing?) to clean out the cylinders. You will be amazed how much junk is left in the crosshatching when you wipe out the cylinder with a rag.

Hope this helps, Ken Wilford http://www.vanagain.com John 3:16 Office (856)-765-1583 Shop (856)-327-0027 Fax (856)-327-2242


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.