Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 2000, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 21 Apr 2000 02:20:37 -0500
Reply-To:     k1cajun <k1cajun@PIPELINE.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         k1cajun <k1cajun@PIPELINE.COM>
Subject:      Re: Friday Jetta "knuckle" problem (No real Vanagon content)
Comments: To: "Tom L. Neal" <jneal@NETCOM.COM>
Content-Type: text/plain; charset=us-ascii

Tom L. Neal wrote:

> < Jetta CV joint story snipped >

> Another odd CV story is that I asked the Olds dealer about repacking the > CV joints on a '91 Olds 98 at 60K original miles and he thought I had > flipped. "Those are sealed and we don't open them." Really? So what > gives with General Motors CV joints? Just run them until they die? They > don't die? Right. The entire rest of the car except the engine has already > died at one time or another so why are the CV joints special?

The Olds 98 is rear wheel drive right (with a front engine that is) ? Then the CV joints on it are on the drive shaft running from the front engine/tranny to the rear differential housing. This setup puts more distance between the two CV joints than on Vanagon drive axles, or any front wheel drive car. So the longer distance means that as the rear suspension goes up and down, the angles that the CV's must assume are much smaller. The CV's movements along the shaft's axis are also smaller. So the smaller demands made of those CV's may allow sealed units.

Now I'm no CV expert, but it can be shown by geometry that the CV's on front-engine/rear-differential cars don't move as much. I've never had to work on that style CV, though I replaced many universal joints, which is what was used on American drive shafts at least up to early 70's. But the American drive shaft CV's I recall seeing when I worked as a grease monkey as a kid, were big things that probably would take up too much room to use at both ends of a front-wheel drive car's axles.

IMHO of course. Dave


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.