I used the Luk kit from Ron and Installed transaxle input shaft seal, rear main seal and o-ring on flywheel, throw out bearing, pilot bearing, New release shaft and all the bushings it rides on and had the flywheel resurfaced. And don't forget the felt seal for pilot bearing. It's been two weeks now and it works great. I used Luk because of lots of talk here about failure of sacks clutch. Good Luck. Dave 1985 van with 217,000 miles |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.