Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 2000, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 25 Apr 2000 21:54:00 EDT
Reply-To:     Z46128@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Daivd Janzen <Z46128@AOL.COM>
Subject:      Re: Questions on clutch kit install, 87 Wolfy
Comments: To: NickMeyers1@aol.com
Content-Type: text/plain; charset="US-ASCII"

I used the Luk kit from Ron and Installed transaxle input shaft seal, rear main seal and o-ring on flywheel, throw out bearing, pilot bearing, New release shaft and all the bushings it rides on and had the flywheel resurfaced. And don't forget the felt seal for pilot bearing. It's been two weeks now and it works great. I used Luk because of lots of talk here about failure of sacks clutch. Good Luck.

Dave 1985 van with 217,000 miles


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.