Hi! I have an '87 Syncro with Digifant ignition. Could someone please tell me if the notch on the crankshaft pulley is at TDC or at 5 degrees before TDC. Bentley, on page 28.41 says to adjust timing 5 degrees before TDC. Then on page 28.42 , Bentley says "notch on V-belt pulley must match separating line on crankcase. Sure would appreciate your help on this. Bob |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.