Date: Tue, 9 May 2000 11:40:31 EDT
Reply-To: JKrevnov@AOL.COM
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Rico Sapolich <JKrevnov@AOL.COM>
Subject: Re: Source for small auxiliary coolant pump? (oil cooler idea!)
Content-Type: text/plain; charset="US-ASCII"
In a message dated 5/9/00 6:49:34 AM, sullivan@OPENMARKET.COM writes:
<< Dear Karl,
Subaru makes a coolant pump that outputs 1800L/hr for their air/water
intercooler -- expensive, but it is designed for your application.
Cheers,
MJS
At 02:58 PM 5/8/00 -0400, Karl M wrote:
>Never one to leave things alone, and in my search for the best oil cooling
>for my TD, I have arrived at a new idea: Use the stock TD water-cooled oil
>cooler, but instead of utilizing the already-hot coolant of the engine's
>cooling system to try to control oil temps, build a secondary cooling system
>dedicated to only the oil cooler. Install a small radiator in front of or
>below the current factory unit (van has no AC), and use a small pump to flow
>the coolant to and fro. I'll also add a temp switch to signal the pump to
>operate only when oil temps exceed the desired amount. I figure this should
>be a lot less strain on the oil system than running an air cooled oil cooler
>up front, with 30 feet of hose. (My recent rear-mounted air cooled unit did
>not control the temps in the high mt. passes of the west, neither did the
>stock cooler) The only part I haven't found is a small coolant pump that
>could be run constantly at 200 or so degree temps. I had thought of using
>the ($$$) Audi aftercool pump from the turbo models, but that isn't really
>designed to run more than a few minutes at a time. Any ideas or comments?
>Thanks.
>
>Karl
>'87 Syncro Westy 1.9 TD
>
Michael J. Sullivan
IPS "SWATteam" Architect
Open Market, Inc.
>>
This is not an elegant solution to the problem. To do it properly, more than
just an H2O circulator (aka, pump), radiator and 30 FT of hose is needed.
What about the pressurizer tank and an anticipator in the control circuit?
Why continue to mix H2O with oil, so to speak, and add all that complexity?
Admittedly, I know nothing about the physical configuration of a 1.9TD engine
compartment but, it seems to me an adequately sized, forced air, oil-to-air
heat exchanger should be able to fit within its confines.
A pertinent question may be: Is the stock cooling system and oil cooler
working properly? After all, that large mass of coolant should be at the
ideal temperature for the oil.
Rich
|