Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2000, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 9 May 2000 19:03:30 -0400
Reply-To:     William Maxian <wmaxian@BELLSOUTH.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         William Maxian <wmaxian@BELLSOUTH.NET>
Subject:      Re: Having Problem with Overheating (1.9l to 2.1l conversion)
Comments: To: KENWILFY@AOL.COM
Content-Type: text/plain; charset=us-ascii

Thermostat in backwards?

KENWILFY@AOL.COM wrote:

> I have been wrestling with this problem all day and I can't seem to put my > finger on it, so I am turning to the list for help. Here is the situation: > > Installed a 2.1l waterboxer engine that was supposed to be running fine into > a '84 Vanagon. > Engine runs great but after about 10-15 mins of running gets hot and I have > to shut it down. > I installed a new waterpump (1.9l) and thermostat (Behr) when I swapped in > the engine as well as bled the system of air like I have a hundred times > before. > One hose (the one to the upper part of the thermostat housing) is getting > very hot, while the other hose (to the lower part of the thermostat housing) > is staying cool. > Radiator is staying cool to the touch to the point where the radiator fan is > not coming on even though the temp gauge says the motor is overheating. > > Things I have tried so far: > 1. Removed new thermostat and tested it in boiling water. Opened at around > 180 degrees F. > 2. Flushed coolant system out with water. > 3. Tried to switch coolant hoses to see if perhaps they had been connected > backwards (no luck). > > The waterpump is spinning merrily and I seem to have pressure at the radiator > (because I can bleed the system there), but no flow through the radiator. > The engine case behind the waterpump was free of scoring when I installed it. > > Anyone ever go through anything like this before? My next step is to try to > install a known good radiator for another van. I just don't understand how > the radiator could be bad. The van only has 55k miles on it and the guy that > had it before me didn't complain of overheating. Of course it sat with the > hoses unhooked for a few weeks and maybe some animal or bees decided it was a > good place for a new home. > > Any ideas or thoughts would be appreciated. > > Thanks, > Ken Wilford > http://www.vanagain.com > John 3:16 > Phone: (856)-765-1583 > Shop: (856)-327-0027 > Fax: (856)-327-2242


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.