Date:         Sat, 13 May 2000 11:51:04 -0400
Reply-To:     Bob Donalds <bostneng@FCL-US.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Bob Donalds <bostneng@FCL-US.NET>
Organization: Boston Engine Exchange
Subject:      Re: Sourcing release shaft and felt seal for pilot for my 87
              Wolfy clutch install
Comments: To: NickMeyers1@AOL.COM
Content-Type: text/plain; charset=us-ascii

Nick Meyers wrote:
>
> Hey! List help!  I ordered my LUK clutch kit from bus depot yesterday with
> all the trimmings, pilot bearing, main seal, o ring etc.....I am still
> looking for the release shaft and felt seal for the pilot bearing.  I spoke
> to Brian at the Bus Depot, he stated that he had not heard of those parts nor
> had part #'s.   He stated I would need part #'s to reference, can someone
> give me the part #'s or lead me to a place where they sell those 2 final
> pieces.  I remember dave from the list(thanks dave) had given me a list of
> parts that I might want to change while doing the install and those 2 were in
> his list of things to change.  Please email me directly, thanks gang!
>
> Nick Meyers

Nick
I am responding to the list to share the correct # for the felt seal its
022 105 311
this is differant than the one that comes in waterboxer the gasket sets
the felt seal thats provided in the gasket sets is to big and is for a
type 1 gland nut
 part # 111 105 311. the small steel insert that holds the felt seal in
place is not availible from the dealer as far as I know. I found a part
# for a lip seal on the type 2 list that they said works its availible
at any bearing supply house the part # for the standard lip seal is
15k21 x 3v6 btcm I have never tryed to order this so good luck the post
that had this number also said that a pinto 2000 or a 2300 pilot bearing
could be used and that it had a seal built in to it
I have no idea that you mean by release shaft seal
Bob