HELP! I can not get system to bleed. Have tried pressure from reservoir and vacuum from slave cylinder without success. I have disassembled and thoroughly cleaned master cyl including the 2 holes under the reservoir tube. Cleaned 3 small holes in piston. Everything looks good. Only possibile problem I can see, perhaps the forward (in direction of flow) cup . Could this swell with age and prevent the valve action of the thin washer over the 3 small holes in the piston. Mast cyl is FAG if there are different ones used. Any/all suggestions appreciated. I have tried all morning to search the archives and I continually get a msg that gerry is to busy to use right now. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.