Corvairs are the same way--horizontal lifters. We used to run a pint of ATF in the oil if the car was used infrequently, as in show car or convertible, not daily beater. It seemed to keep them quiet. Interestingly enough, the Chevrolet manuals also called for 2 turns from zero lash. We would adjust the lifters while the car was running, using a half valve cover. You back off the rocker nut until it clacks, wait to see if it will pump up more... Once you found the quiet point, you tightened to pre-load. We all found 2 turns was way too much also! Most of us run 1/4 or 1/2 turn at the most. You may get some noise on start-up, but it quickly goes away. 2 turns would burn your valves in no time. (They are air-cooled and do run hot.) I think in the new motors with new lifters, 2 was OK, but not on a high mileage car. I am currently running new lifters in my '85 Westy. I think I will go back over them and see exactly where they are at right now. I may want to back them off some and see if the power increases and whether or not I get any start-up noise. Jay |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.