Date:         Thu, 25 May 2000 23:15:57 EDT
Reply-To:     Wolfvan88@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Robert Lilley <Wolfvan88@AOL.COM>
Subject:      Re: powder coating exhaust
Comments: To: transporter99@hotmail.com
Content-Type: text/plain; charset="US-ASCII"

Before you install your exhaust system make sure all the pipes bolt together
without any one fitting off center.  On my exhaust the elbow did not fit
centered.  I had to grind about a quater inch of material out to remove the
restriction.  Check by using the exhaust gasket as a template.  Doing this
work removes restrictions to the exhaust and give you a little free HP and
stock WBX's need it...


Robert

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.