Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2000, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 22 May 2000 12:37:58 -0700
Reply-To:     BRENT CHRISTENSEN <bchristensen@INFOGENESIS.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         BRENT CHRISTENSEN <bchristensen@INFOGENESIS.COM>
Subject:      Speaker wire repair and impressions of Vanagon door wiring in gen
              eral
Content-Type: multipart/alternative;

Yesterday I finally got around to fixing my dead left front speaker. Sure enough, the blue speaker wire had been severed by the action of the door. (The break was located inside the rubber boot that runs from under the dash to the door at the hinge). First of all, this was a major PITA to work on - the break was located deep inside the rubber "conduit", and I could not see any easy way of removing it. I actually had to pull it back very forcibly, and then hold it there with some hemostats (medical clamps for blood vessels) so that I could get to the break point of the wire.

Unfortunately, the wire was so filthy that I could not get a good solder joint (and I couldn't strip it back any farther). I ended up using a solderless butt connector. :-(

While I was inside the rubber conduit, I noticed that several of the other wires were beginning to give way as well (cuts or breaks in the insulation). I could not get at them to repair them, even though I removed all the door panel and trim. I even pulled all the cable ties that were holding the wire bundles and removed the "vapor barrier" (plastic sheeting)., but I still couldn't move the wire bundles to a position that would allow more flexibility.

Has anyone ever successfully re-wired their door in order to replace these broken (or breaking) wires? What needs to be done in order to get to the wires inside that piece of rubber conduit? I am planning to replace the 4" Alpine font speakers with something else bigger soon, and I want to replace the old broken wires. I prefer to run the wires inside the existing loom if at all possible, but it looks to be a MAJOR PITA to get that rubber conduit moved out of the way...

Brent Christensen '89 GL Syncro Westy Santa Barbara, CA


[text/html]


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.