Steve, I am working on an article to do this, along with a caliper rebuild and pad install. I am waiting for my other rotor to come back from the Bus Depot to complete the other side to take the photos. The pickle-fork method DID NOT WORK for me. Plus, I did not like banging on the suspension arms. I tried to use a small two arm puller and that failed also, to small. I tried to heat the joint during the pully attempt, but that did not work either. I tried for several days without success. I put it back together and drove for about a year until I got the correct tool. What worked and what will work is: Tools: Medium sized heavy duty two arm puller ***Small tie rod end extractor. OR medium to large tie rod extracter tool ***If you get the bigger tie rod extractor- you do not need to buy the smaller- because you do not have to remove it. *I used a medium Heavy Duty puller to remove the upper joint. (Mainly because I had bought the puller to do the job, but the tie rod extractor would be easier) *I removed the tie rod end with a small tie rod end remover. The tool made it very EASY and did not damage the tie rod end.. Jack van up. Remove wheel remove caliper remove caliper mount. remove tie-rod end from spindle arm (do not loosen nut) remove upper allen bolts on ball joint remove the lower ball joint from the spindle arm with the puller. Lay free spindle on ground and attach puller to the upper ball joint and tightened until it pops off. Mine took a LOT of force. When it broke free it shot about 15' across my driveway making a loud pinging noise. Then reassemble it all back. You do not have to get a anlignment after- Local VW shop told me this.
***An easier way is to use a medium tie rod puller and remove only the caliper mount to make room for the tool and then remove the upper ball joint. *Measure the width of the spindle arm at the top to make sure you get the correct width. *The tool is @$12-$15 at auto zone or your FLAPS.
Jack van up. Remove wheel remove caliper remove caliper mount. remove the upper allen bolts and then use the tool to remove the joint Reassemble With the correct tools, the job is easy! Robert |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.