Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (June 2000, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 20 Jun 2000 08:33:27 -0500
Reply-To:     Joel Walker <jwalker@bama.ua.edu>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Joel Walker <jwalker@bama.ua.edu>
Subject:      Re: Seeking comments on Muffler Replacement
Content-Type: text/plain; charset="iso-8859-1"

> you had difficulty on an '87/88. However, I have had a couple of people who > started to install the muffler backwards and found that the muffler straps > did not clear the heat shield. I told them to flip the muffler around and, > sure enough, it fit.

tried that: no joy. plus the flange for the catalytic converter is a pass-through bolt hole, while the flange for the tailpipe is a threaded bolt hole. i kinda don't think the two flanges are interchangeable.

> aware of this having happened. In such a case, I'd imagine you could simply > cut away a part of the heat shield with tin snips and end up no worse off > than with a stock muffler (which lacked the shield anyway). But you really > shouldn't have to, since by design the gaps in the heat shield do allow for > the use of the stock straps.

tried that as well. still no luck. all it did was make a mess with the insulation material. even with the heat sheild removed on the catalytic converter end, it simply would not fit with both brackets in place. if you got it to work on yours, great. i did not get it to work on mine.

but this is the risk we take with aftermarket parts. in 30 years of running and working on buses, it's a known risk and i've learned to accept it. some aftermarket parts are worse than others. even some dealer-sold 'vw' parts don't always fit. mostly due to, i think, some dealers being worse than others .... i've had a dealer try to sell me a freshly-cleaned-off voltage regulator (for a 71 bus) that was still dripping in solvent as a "new" part!!! but my experience has been that 90 percent of the dealer parts do fit, whereas about maybe 50 percent of aftermarket stuff fits well enough. you pays your money and you takes your chances. but to say that an ill-fitting aftermarket part is always or even usually the fault of the bus-owner and installer, is, i think, just wrong ... parts shouldn't have to be forced to fit, even when replacing only one part of a rusty old exhaust system.

unca joel


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.