Not so fast buddy... I did a few phone calls around here and all I could find is length 30 or 40mm. No 35. I suspect 30 or 40 would fit, but I'm not sure, I haven't looked at the mechanism. As for stainless steel, no luck. The largest fastener supplier in town tells me that fine thread stainless steel (which is what the 1.5 refers to in the number) is VERY RARE. There ya go. Éric p.s. All this applies to Ottawa/Canada
At 09:58 AM 20/06/00 -0400, =David-M= wrote: >David, >ETKA says: M12 x 1.5 x 35 >Any hardware stores should cary this metric-size bolt. Try to get it in stainless steel! >Éric |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.