Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2000, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 16 Jul 2000 06:36:04 EDT
Reply-To:     RAlanen@aol.com
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Frank Condelli <RAlanen@aol.com>
Subject:      Re: Cooling woes and the aborted trip to TBTT (somewhat
              longish...)
Comments: cc: arbosch@ra.rockwell.com
Content-Type: text/plain; charset="US-ASCII"

In a message dated 7/16/00 12:02:05 AM Eastern Daylight Time, LISTSERV@GERRY.VANAGON.COM writes:

<< Cooling woes and the aborted trip to TBTT (somewhat longish...) >>

Alan, first you need to determine if your actually loosing coolant and if the motor is actually overheating. Check the main coolant tank fluid level. Under normal circumstances it should be full right up to the top. No air space ! If the engine is overheating it will be obvious. Steam/vapor will be rising from it. The temp sensor flashing light indicates coolant level. When it is flashing the coolant level in the main tank is too low. If the coolant level in the tank is not low and the light is flashing then either the sensor in the tank is bad (sensor is right on top of the tank and is common to failure) or the coolant sensor light control unit is malfunctioning (another common problem) it's located in the fuse box under your dash. It is one of the plug-in square boxes, I don't recall which one off hand but look in your Bentley and you'll find it's number. The main coolant tank cap could be the culprit also. The valve in it could be kaput and allowing coolant to go back and forth to the overflow tank when it's not supposed to. When the main tank is full and the engine is running a the coolant system become pressurised and the cap is supposed to not allow coolant out. It should only allow coolant in from the overflow tank when there is need. The overflow tank need to have coolant or air will be sucked in if the main system needs coolant. And if the main system is in need of coolant then it is leaking out somewhere. Hope this helps track down your problem and get's you not the road to an adventure next weekend. Good luck.

Cheers

Frank Condelli '87 Westy & Lionel Trains Vanagon List, LIMBO & IWCCC member Vanagon/Vanagon Westfalia Service for the Ottawa Valley STEBRO/Vanagon Stainless Steel Exhaust Systems Almonte, On Visit me on the web.......> <A HREF="http://members.aol.com/Fkc43/busindex.html">Frank Condelli & Associates< /A> or http://http://onward.to/frankcondelli Want to win $10,000? Click to enter!! <A HREF="http://irecommend-it.com/sh.e?22EC343C3B75">iRecommend-It Public Page for RAlanen@aol.com</A>


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.