Sounds like you have a sensor failure. There is a pressure switch at the very back end of the engine at the very back end of the van right down on bottom of the block just under the crankshaft pully. I had one of these to fail. Just unscrew it, and install a new one. Not expensive, but a PITA to get to, but you can get to it from up top. Don't have to get under the van. The other switch is located between the push rod tubs on the right side of the engine. It is a bit more problimatic to get to, but can be done. Hope this helps a bit. Good Luck. John Rodgers "88GL Driver in Birmingham, AL Daniel Danrich wrote: > Oil sensor still buzz after going to Mahle oil filter, now what? > Dan |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.