Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2000, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 7 Aug 2000 15:48:43 EDT
Reply-To:     KENWILFY@aol.com
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         KENWILFY@aol.com
Subject:      Re: Fuel Line Clamps
Comments: To: sxs@concentric.net
Content-Type: text/plain; charset="US-ASCII"

The only reason to go with the crip on clamps versus the worm style clamps would be that you wouldn't have to worry about the worm drive eating into the hose. The clamps I sell are not worm drive, but are a band style clamp (like the crimp clamps) that is merely tightened with a stainless screw (no cutting into lines). The edges of the clamps are rolled to prevent biting into the lines. The clamps I sell are ABA swedish stainless clamps that are top quality. The crimp clamps are plain steel and will rust again in the future. So why go to the trouble to buy a special tool to install a clamp that, if you decide to remove a hose in the future for some reason, you will have to cut off of the line? A clamp which will rust and eventually fail, when you can buy my hose kit, which comes with the stainless clamps which are tightened by either a slotted screw driver or a small socket for only $53? The kit comes with the hose needed to do the engine compartment, 20 stainless clamps, and a instruction sheet on how to do it. Hope this helps you make your decision.

Thanks, Ken Wilford http://www.vanagain.com John 3:16

New Phone (856)-327-4936 Shop: (856)-765-1583 Fax: (856)-327-2242


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.