> > All > > the Audi Motronic engines have their crank position sender on the > flywheel. > > The SA bellhousing doesn't have this provision. > > Thatīs right, but that is no problem on the SA bellhousings. The company > here in Bremen that does the Audi V6 conversions (my inspirators!) use this > bellhousing and cut a hole in it (max 3x3cm). No problems so far, and almost > every company here in Germany that installs 5-cyl (Winkler etc.) use the SA > bellhousing.
One more to add: The sender on the flywhell is the rpm sender. The crank position sender is located in the engine block, at least the Audi V6 12V has one there. My new V6 30V has one sender only, a combined postion/rpm sensor, indeed located next to the flywheel. Raimund |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.