Date: Tue, 8 Aug 2000 09:15:20 -0400
Reply-To: David Beierl <dbeierl@attglobal.net>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: David Beierl <dbeierl@attglobal.net>
Subject: Re: Refrigerator doesn't work yet.
In-Reply-To: <v04010505b5b55b119b29@mars.netspace.or.jp>
Content-Type: text/plain; charset="us-ascii"; format=flowed
At 02:42 8/8/2000, Yoshi wrote:
>I removed the outside tank. The tank is in the left box of the refrigerator
>now. I will check the tank pressure.
>Look.. http://menbers.aol.com/winpai/11gas.jpg
I see you have a single-stage regulator which is not sufficient for this
job. You need 1) a two-stage regulator and 2) it must have an inlet
fitting which will shut off the gas in case of a large leak. In USA that
is called "excess-flow POL fitting" -- POL is the name of the round-nosed
fitting with left-hand thread that couples the regulator to the valve on
the external tank. The male (regulator) side contains the mechanism to
shut off excessive flow.
In USA these devices must have regulatory approval for RV use and will be
marked as such. The standard replacement for the square Marshall Brass 260
regulator which was original equipment is the (longer, <sigh>) Marshall
Brass 290 which still fits with some bending of the tubing going into the van.
> > elevations up to perhaps 500 meters?
>
>Did you say the altitude?
Yes
>I went to Gas-station today. Then, I asked about the Japanese Gas standard.
>He said to me.
>The pressure level from the tank-hose.---->230~330mmH2O
American spec is 11 or sometimes 11.5 inches H2O; 11 inches = 280mm. I do
not think the tolerance is as large as you state. I think perhaps that
tolerance is for barbecue grill regulators, not RV regulators. The
instructions from Dometic seem to suggest a tolerance of maybe only +/-
10mm for best performance.
>Burner combustion levels.----------> 200mmH2O up
Don't know.
>The component of Gas.-------------> 80%-up Propan, 20%-Butan
I believe this is the same.
>The gas pressure is possible with the regulater valve(Incl level meter).
>However, I don't have it now. My gas-regulater always supplies the gas to
>the refrigerator in the constant level.
I understand that when you say level you mean pressure. :) I am only
familiar with the Marshall Brass series of regulators, which have
adjustment for the second (low-pressure) stage, but not a gauge. A gauge
to measure this very small pressure will be quite expensive, probably more
than the regulator itself. Is it possible that your best answer will be to
have someone here obtain and send you a correct regulator? They cost under
$30 US including the POL fitting and weather covers.
david
ps -- are you anywhere near Gumma-Ken? I have a friend who lives at the
special hospital there.
David Beierl - Providence, RI
http://pws.prserv.net/synergy/Vanagon/
'84 Westy "Dutiful Passage"
'85 GL "Poor Relation"