I have an '84 Vanagon that I'd like to begin working on. My question is, Where do I start? Here's my dilemma: I have no mechanical background, but eager to learn. Have the books: Muir, Bentley, Haynes. Have most of the tools I think I'll need. First some diagnostics: The PO told me the #2 cylinder was "bad" but I don't know what he meant by it. I did a compression test and it looked lousy (or so I assume): Cylinder 6 tries per the Muir book 1 90-80-85-85-85-85 2 75-70-75-70-70-70 3 100-100-95-100-105-95 4 100-85-85-95-85-95 Would this be corrected with new rings, I wonder? Or should I trash the engine? Again, I'm speculating,bcse I still need to pull the engine. From what I presume, inspecting the inside of the cylinder for damage is paramount. I would hate to have to split the case. Am I in over my head? Thanks in advance.
Carlos |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.