Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2000, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 7 Aug 2000 23:24:59 -0400
Reply-To:     "Carrington, Tom" <TCarrington@ReliTech.com>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         "Carrington, Tom" <TCarrington@ReliTech.com>
Subject:      FW: rear heater
Content-Type: text/plain

> -----Original Message----- > From: Mladen, Zoran [SMTP:zmladen@solant.com] > Sent: Monday, August 07, 2000 11:06 AM > To: vanagon@GERRY.VANAGON.COM > Subject: RE: rear heater > > > It is not necessary to replace the floor boards. I had this problem with > my > Vanagon. I removed the carpets and floor boards and performed an > intensive > cleaning to remove all of the coolant. The carpets were easy. The floor > boards were more difficult. I continuously ran water over the infected > areas for about five minutes, and then stood the boards up against a fence > to let them dry (this allowed the coolant to drip out with the water as > they > dried). In my case, there was one half of the boards that were soaked and > the other half was still ok. So when hanging the boards to dry, be sure > to > hang the infected side down, so that the water will take the coolant away, > rather than pushing it further into the inaffected side. > > I repeated this procedure several times, I would guess about 6-7 times on > the worst board. When I let them dry, I didn't let them dry completely. > I > watched them during the drying process, and you can see water/coolant. > When > the dripp ing stopped, I repeated the process. When you think you are > done, > let the board dry completely. If it dries, you have been successful. If > it > remains wet, there is still coolant inside, as coolant will not dry while > in > the board. > > I try to limit my spending on my Vanagon. This process was time consuming > (2 days elapsed time of letting the boards dry and rewetting), but now my > boards are dry as a bone and ready for the next rear heater failure! > > Z > > -----Original Message----- > From: Bill Davidson [mailto:wdavidson@thegrid.net] > Sent: Monday, August 07, 2000 8:53 AM > To: vanagon@GERRY.VANAGON.COM > Subject: Re: rear heater > > > > Will removing and replacing the rear heater with a new one eliminate the > > maple syrup smell? > > If it was leaking coolant... and if there was a lot spilled and you clean > it > up... including (if a lot was leaked) removing and replacing the floor > boards which soak it up. > Bill


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.