Greetings and Salutations; I thought I would share (again) a quick check method I discovered. It must be done after the vehicle has set overnight. From the ECU's connector hold one of your VOM's leads on pin six. Alternately compare readings between pins nine and ten with the other lead.* Theoretically if both sensors are at the same temperature then their resistances should be equal.
Drive Safely & Good Luck Ken Lewis <Kernersville,NC> 86 VW crewcab;60 356B Coupe -------------------------------------------------- *DIGIFANT wiring harness only. ________________________________________________________________ YOU'RE PAYING TOO MUCH FOR THE INTERNET! Juno now offers FREE Internet Access! Try it today - there's no risk! For your FREE software, visit: http://dl.www.juno.com/get/tagj. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.