Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2000, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 15 Aug 2000 22:23:09 -0500
Reply-To:     John Rodgers <inua@hiwaay.net>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         John Rodgers <inua@hiwaay.net>
Subject:      Re: Engine warm-up troubles
Comments: To: AL Ferguson <aferguso@brazosport.cc.tx.us>
Content-Type: text/plain; charset=us-ascii

Sounds like idle stabilizer troubles to me. You may need to clean yours. There could be other things as well. The 900 RPM is the correct idle speed.

John Rodgers 88GL Driver

AL Ferguson wrote:

> I am having a little trouble in the morning with warming the engine of > my '87 Westy (gas). > It starts fine and even revs a little higher (1300 RPM) then idle ~ like > some sort of choke action is taking place. The RPMs drop back down to > about 900 almost immediately (about 2 ~ 3 seconds of higher revs) If I > stick it in gear (automatic) and give it gas at this point, no go. The > engine doesn't accelerate at all - kinda acts like it is bogging down - > it will creep forward but not accelerate (this is the problem). After > about a small city block it begins to run perfectly for the rest of the > day unless the engine gets cold again. This happens everyday. Now if I > let it sit and warm-up for a couple minutes it will take off fine. > I know I should let warm up completely first etc. BUT I shouldn't have > to. Of greater concern to me is when it gets really cold outside (in > Colorado), I'm concerned that this problem will get worse. > I bought the Van about 3 months ago and it has always acted this way. > Other vans I have owned in the past did not. > > Here is what I have seen to check from the archives: > > Checked Temp sensor 1 with ohm meter - it reads in spec. The air flow > meter was just replaced about 3 months ago. Did all the ohm checks on it > and all seems in order. > > Check temp sensor II. It to was in ohm spec. range. > > Drained gas tank - Installed new fuel filter/fuel. > > That's all I know to do. > > Any suggestions that a do-it-youself'r-can do? > > Thanks, > Al Ferguson > aferguso@brazosport.cc.tx.us


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.