Date:         Thu, 31 Aug 2000 22:03:48 -0400
Reply-To:     Dan Johnston <johnstond@MAILSERVER.VOLVO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dan Johnston <johnstond@MAILSERVER.VOLVO.COM>
Organization: Volvo Cars of North America
Subject:      water temp sensor -leaving on vac
Content-Type: text/plain; charset=us-ascii

I'm leaving on vacation next week and trying to figure out why my gauge
is reading soo low. i'll check the wires but they look ok.

big question, do i need to bleed the system after replacing the sensor?
and is it best to replace it from under the van or above?

thanks,
dan
87 westie

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.