Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2000, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 4 Sep 2000 16:05:40 -0700
Reply-To:     Michael Snow <mwsnow@HOME.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Michael Snow <mwsnow@HOME.COM>
Subject:      Re: Engine Running cold
In-Reply-To:  <01C01719.243A5DC0.ddelben@airinter.com.au>
Content-Type: text/plain; charset="US-ASCII"

The engine needs to get hot enough (180F or more) for the contaminants that accumulate in the engine oil to evaporate. I wondered for a while why my van (diesel Westy) ran so cool until I discovered that the PO had removed the thermostat and not replaced it. The thermostat is an essential component of a good running engine. In extreme circumstances (unlikely in a Vanagon due to the unusually large volume of the cooling system) the coolant can flow so quickly through the radiator that it does not lose enough heat, causing overheating and engine destruction. Even when fully open, the thermostat provides water flow restriction to force the coolant to stay in the radiator sufficiently long for adequate heat loss to occur.

Install the right thermostat for your year and model of van and don't scrimp on some cheapie.

P.S. I discovered that the radiator was completely plugged after replacing the missing thermostat!

My 2 cents, Mike Snow

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@GERRY.VANAGON.COM]On Behalf Of David Del Ben Sent: Monday, September 04, 2000 3:10 PM To: vanagon@GERRY.VANAGON.COM Subject: Engine Running cold

Hi all, Have an issue with my engine running cold. The temperature gauge pretty much stays o the edge of the white shaded area of the gauge. I'm pretty confident the gauge is reading accurate as we have just passed thru a winter here and it takes a while for the Heater to warm up and get decent hot air from the vents. Also, sometimes, stuck in traffic, the needle does sway more to the middle of the gauge (where it should be) and you can feel nice hot air from the vents.

I very much suspect the thermostat is stuck open - but I've performed a 'band-aid fix' by substantially blocking of air to the radiator to try & get it to run a bit warmer.

My question: I've been reading on the list about the lengths people go to to put oil temp gauges & head temp gauges and all sorts of tricks to keep an eye on the engine (head) temps. Seems to be a critical sort of thing. Hey - why don't I just leave the thermostat as it is and let the engine run a little cooler. Is that going to be better for the engine? As I said - we've just come out of winter - and I managed with the Heater as it is.

Any thoughts - anyone.

David Del Ben 85 1.9 Vanagon


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.