Carlos; I am currently using Simple Green and Elbow Grease. About a one to twenty ratio. I have amassed a collection of different size brushes and drill attachments also. The small parts can be boiled. I used a coffee can on a Coleman stove. The pushrod tubes came out like new! I used an extra large bottle brush to clean their insides. Small bottle brushes attached to a drill worked great on the oil galleries. I have a small,junk, counter top toaster/oven to dry ferrous parts to prevent rust. Drive Safely & Good Luck Ken Lewis <Kernersville,NC> 86 VW crewcab;60 356B Coupe -------------------------------------------------- On Fri, 1 Sep 2000 12:56:16 -0400 Carlos Del Rio <cdelrio@CONCENTRIC.NET> writes: >What's recommended for cleaning the engine: parts, tins, et al.? >I read kerosene, gasoline, "solvent" (too generic a term). And how >does one >go about eliminating the waste? >TIA > >Carlos >www.myhealth.com/Carlos_DelRio >AOL Instant Messenger: cadelrio >ICQ# 34175672 ________________________________________________________________ YOU'RE PAYING TOO MUCH FOR THE INTERNET! Juno now offers FREE Internet Access! Try it today - there's no risk! For your FREE software, visit: http://dl.www.juno.com/get/tagj. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.