The outer bushings on the front stabilizer bar need to be replaced(83.5 westy). Bentley shows a lovely picture of the assembly(page 40.2), but not a word on how to replace them. I picked up the bushings today, $16.00 for the pair, and have to get them in tomorrow. Any hints or trick to keep the aggravation level to a minimum would be appreciated. As far as I can tell I'll proceed as follows -loosen or remove stabilizer link -remove old bushing -lube new bushing (dish detergent?) -slip bushing on stabilizer bar -wrestle link over bushing and re-tighten Sound feasible? Any hints greatly appreciated Thanks, Jim, Surrey BC
[text/html]
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.