I put spacers on top of the rubber that fits > onto the top of each left hand spring (front and rear), front spacer > was 1/8" and rear was 1/4". Mike.... any way you can give complete specifications for makeing these spacers? like are they round? and what is the diameter? and what did you make them out of? I want to have a mechanic install my springs and I figure I would have to make the spacers for him before I take it to the shop (I don't think the mechinic will be willing to fabricate the spacers himself and I wouldn't have time to take measurements after he removes the old springs and fabricate the spacers while he works at installing the new springs.) Thanks.. Bill |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.